Yaesu FTdx1200 manual

The FTdx1200 from Yaesu provides up to 100 Watts on SSB, CW, and FM (25 Watts AM carrier). Similar to the high-end YAESU FT DX series, it uses 32-bit high-speed floating-point DSP. Yaesu’s new DSP algorithms are highly effective in weak signal processing and enhancement. The 1st IF frequency is protected by selectable 3 kHz, 6 kHz, and 15 kHz roofing filters too. The triple conversion circuit structure allows highly flexible gain distribution at each stage.

Download the Yaesu FTdx1200 manual

For safe and optimum performance, the Yaesu FTdx1200 must be used properly. Carefully read and follow all instructions and guidelines in this manual and give special attention to the CAUTION and WARNING statements. Misuse may damage the unit and/or cause harm or serious injury.

Overall, the Yaesu FT-DX1200 is a modern all-mode HF/6m transceiver with a huge 4.3″ full-color TFT display and a built-in 32-bit high-speed floating-point digital signal processor (offers adjustable IF width, IF shift, notch filter, contour control, and DNR). The radio features a built-in high-speed automatic antenna tuner, built-in high-speed spectrum scope display, built-in high stability crystal oscillator, triple-conversion receiver design, three built-in roofing filters (3, 6, and 15 kHz), and multiple scanning modes, and more. The radio is supplied with a hand microphone with up/down frequency controls and a fused DC power cord.

Share this post: